Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 958

IPv6 Software Access Control List (ACL) Commands
Software Reference for x310 Series Switches
37.6
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
Mode
Global Configuration
Default
Any traffic controlled by a software ACL that does not explicitly match a filter is denied.
Usage
Use IPv6 extended access-lists to control the transmission of IPv6 packets on an interface,
and restrict the content of routing updates. The switch stops checking the IPv6 extended
access-list when a match is encountered.
gt
For TCP/UDP
Matches port numbers greater than the port number
specified immediately after this parameter.
ne
For TCP/UDP
Matches port numbers not equal to the port number
specified immediately after this parameter.
<icmp-type>
For ICMP|IP
The ICMP type, as defined in RFC792 and RFC950. Spec-
ify one of the following integers to create a filter for the
ICMP message type:
0
Echo replies.
3
Destination unreachable mes-
sages.
4
Source quench messages.
5
Redirect (change route) mes-
sages.
8
Echo requests.
11
Time exceeded messages.
12
Parameter problem messages.
13
Timestamp requests.
14
Timestamp replies.
15
Information requests.
16
Information replies.
17
Address mask requests.
18
Address mask replies.
log
Logs the results.
Parameter(cont.)
Description(cont.)