Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 336)

Interface Testing Commands
Software Reference for x310 Series Switches
13.2 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Command List
This chapter provides an alphabetical reference of commands used for testing interfaces.
clear test interface
This command clears test results and counters after issuing a test interface command. Test
results and counters must be cleared to issue subsequent test interface commands later
on.
Syntax clear test interface {<port-list>|all}
Mode Privileged Exec
Examples To clear the counters for port1.0.1 use the command:
To clear the counters for all interfaces use the command:
Related Commands test interface
Parameter Description
<port-list> The ports to test. A port-list can be:
■
a switch port (e.g. port1.0.6)
■ a continuous range of ports separated by a hyphen,
e.g. port1.0.1-port1.0.6
■
a comma-separated list of the above,
e.g. port1.0.1,port1.0.5-1.0.6
The specified ports must exist.
all All interfaces
awplus# clear test interface port1.0.1
awplus# clear test interface all