Up-count, Undebug ping-poll, Up-count <1-100 – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 2080: Up-count undebug ping-poll, Count

Ping-Polling Commands

Software Reference for x310 Series Switches

79.22

AlliedWare Plus

Operating System - Version 5.4.4C

C613-50046-01 REV A

up-count

This command sets the number of consecutive pings that the polling instance must
receive a reply to before classifying the device reachable again.

The no variant of this command resets the up count to the default of 30.

Syntax

up-count <1-100>

no up-count

Default

The default is 30.

Mode

Ping-Polling Configuration

Examples

To set the upcount to 5 consecutive pings for ping-polling instance 45, use the
commands:

To reset the upcount to the default value of 30 consecutive pings for ping-polling instance
45, use the commands:

Related Commands

critical-interval
fail-count
normal-interval
ping-poll
sample-size
show ping-poll
timeout (ping polling)

undebug ping-poll

This command applies the functionality of the

debug ping-poll command on page

Parameter

Description

<1-100>

Number of replied pings before an unreachable device is classified as
reachable.

awplus#

configure terminal

awplus(config)#

ping-poll 45