Server enable – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1352

Local RADIUS Server Commands
Software Reference for x310 Series Switches
51.24
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
server enable
This command enables the local RADIUS server. The local RADIUS server feature is started
immediately when this command is issued.
The no variant of this command disables local RADIUS server. When this command is
issued, the local RADIUS server stops operating.
Syntax
server enable
no server enable
Default
The local RADIUS server is disabled by default and must be enabled for use with this
command.
Mode
RADIUS Server Configuration
Examples
To enable the local RADIUS server, use the following commands:
To disable the local RADIUS server, use the command:
Related Commands
show radius local-server statistics
awplus#
configure terminal
awplus(config)#
radius-server local
awplus(config-radsrv)#
server enable
awplus#
configure terminal
awplus(config)#
radius-server local
awplus(config-radsrv)#
no server enable