Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1190)

Authentication Commands
Software Reference for x310 Series Switches
43.64 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show auth-mac diagnostics
This command shows MAC authentication diagnostics, optionally for the specified
interface, which may be a static channel (or static aggregator) or a dynamic (or LACP)
channel group or a switch port.
If no interface is specified then authentication diagnostics are shown for all interfaces.
Syntax show auth-mac diagnostics [interface <interface-list>]
Mode Privileged Exec
Example To display authentication diagnostics for port1.0.6, enter the command:
Output Figure 43-3: Example output from the show auth-mac diagnostics command
Parameter Description
interface Specify an interface to show
The interfaces or ports to configure. An interface-list can be:
■ an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
■
a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen;
e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2, or
po1-2
■
a comma-separated list of the above;
e.g. port1.0.1,port1.0.4-1.0.6. Do not mix
interface types in a list
The specified interfaces must exist.
awplus# show auth-mac diagnostics interface port1.0.6
Authentication Diagnostics for interface port1.0.6
Supplicant address: 00d0.59ab.7037
authEnterConnecting: 2
authEaplogoffWhileConnecting: 1
authEnterAuthenticating: 2
authSuccessWhileAuthenticating: 1
authTimeoutWhileAuthenticating: 1
authFailWhileAuthenticating: 0
authEapstartWhileAuthenticating: 0
authEaplogoggWhileAuthenticating: 0
authReauthsWhileAuthenticated: 0
authEapstartWhileAuthenticated: 0
authEaplogoffWhileAuthenticated: 0
BackendResponses: 2
BackendAccessChallenges: 1
BackendOtherrequestToSupplicant: 3
BackendAuthSuccess: 1