beautypg.com

Show interface memory – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 233

background image

System Configuration and Monitoring Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

TM

Operating System - Version 5.4.4C

8.33

show interface memory

This command displays the shared memory used by either all interfaces, or the specified
interface or interfaces. The output is useful for diagnostic purposes by Allied Telesis
authorized service personnel.

For information on output options, see

“Controlling “show” Command Output” on

page 1.37

.

Syntax

show interface memory

show interface <port-list> memory

Mode

User Exec and Privileged Exec

Example

To display the shared memory used by all interfaces, use the command:

To display the shared memory used by port1.0.1 and port1.0.5 to port1.0.6,
use the command:

Output

Figure 8-7: Example output from the show interface memory command

Parameter

Description

The ports to display information about. The port list can be:

a switch port (e.g. port1.0.4) a static channel group (e.g. sa2)
or a dynamic (LACP) channel group (e.g. po2)

a continuous range of ports separated by a hyphen,
e.g. port1.0.1-1.0.4, or sa1-2, or po1-2

a comma-separated list of ports and port ranges,
e.g. port1.0.1,port1.0.4-1.0.6. Do not mix switch ports,
static channel groups, and dynamic (LACP) channel groups in the
same list

awplus#

show interface memory

awplus#

show interface port1.0.1,port1.0.5-1.0.6 memory

awplus#show interface port1.0.1,port1.0.5-1.0.6 memory
Vlan blocking state shared memory usage
---------------------------------------------
Interface shmid Bytes Used nattch Status
port1.0.1 393228 512 1
port1.0.5 491535 512 1
port1.0.6 557073 512 1