Introduction, Command list, Clear lldp statistics – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1928: Introduction command list, Clear lldp statistics [interface
LLDP Commands
Software Reference for x310 Series Switches
71.2
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
Introduction
LLDP and LLDP-MED can be configured using the commands in this chapter, or by using
SNMP with the LLDP-MIB and LLDP-EXT-DOT1-MIB (
Voice VLAN feature can be configured using commands in
. For more information about LLDP, see
Chapter 70, LLDP, LLDP-MED and
Voice VLAN Introduction and Configuration
LLDP can transmit a lot of data about the network. Typically, the network information
gathered using LLDP is transferred to a Network Management System by SNMP. For
security reasons, we recommend using SNMPv3 for this purpose (
,
LLDP operates over physical ports only. For example, it can be configured on switch ports
that belong to static or dynamic channel groups, but not on the channel groups
themselves.
Command List
This chapter contains an alphabetical list of commands used to configure LLDP.
clear lldp statistics
This command clears all LLDP statistics (packet and event counters) associated with
specified ports. If no port list is supplied, LLDP statistics for all ports are cleared.
Syntax
clear lldp statistics [interface <port-list>]
Mode
Privileged Exec
Examples
To clear the LLDP statistics on ports 1.0.1 and 1.0.6, use the command:
To clear all LLDP statistics for all ports, use the command:
Related Commands
show lldp statistics interface
Parameter
Description
<port-list>
The ports for which the statistics are to be cleared.
awplus#
clear lldp statistics interface port1.0.1,port1.0.6
awplus#
clear lldp statistics