Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2159)

Stacking Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 83.19
stack management subnet
This command configures the subnet address used by the stack management VLAN.
Use the no variant of this command to reset the stack’s VLAN subnet management
address back to the default address and mask (192.168.255.0/27).
Syntax stack management subnet <ip-address>
no stack management subnet
Default The default stacking management VLAN subnet address is 192.168.255.0 with a subnet
mask 255.255.255.224 or /27.
Mode Global Configuration
Usage This command configures the stack management VLAN subnet address.
The management VLAN will be used for high speed communication between stacked
units via the stacking ports. Although this command enables you to change the IP address
command, the subnet mask must always remain as shown.
The stack management IP subnet is solely used internally to the stacked devices, and
cannot be reached external to the stack. You should only change the stack management
VLAN subnet address if it causes a conflict within your network.
Note that several separate stacks can use the same default management VLAN subnet
address even though their user ports may share the same external network. If the stack
subnet address is changed, then the configuration for any new units must also be updated
before they are inserted into the stack.
If the management VLAN subnet address is changed by this command, you can use the no
variant of this command to reset it to it’s default.
Example To set the management VLAN subnet address to 192.168.255.144:
Related Commands stack management vlan
Parameter Description
The new subnet address for stack management VLAN.
awplus# configure terminal
awplus(config)# stack management subnet 192.168.255.144