Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 1582

AMF Introduction and Configuration

Software Reference for x310 Series Switches

59.38

AlliedWare Plus

Operating System - Version 5.4.4C

C613-50046-01 REV A

Sub-configuration limitations for some nodes in a working-
set

There will also be some instances where a sub-configuration mode is only valid for some
of the nodes in the working-set. One example of this case would be when entering
interface configuration mode for a port that exists on some members of the working-set
and not on others. For example:

In the example above the interface port2.1.1 exists on two of the nodes in the working-
set, but doesn’t exist on nodes “Master” and “x510_1”. The interface configuration mode
fails for these nodes and a warning message is output to indicate this. The numbers within
the square brackets next to the AMF network name prompt also change. The first number
indicates the total number of nodes in the working set, and the second number indicates
the number of nodes in the sub-configuration mode that has been entered. Any
configuration commands configured in this mode will only be executed on the nodes that
successfully entered the sub-configuration mode.

atmf1[4]# show card

=======

Master:

=======

Slot Card Type State

--------------------------------------------------------------------

1 AT-SBx81GP24 Online

2 AT-SBx81GP24 Online

3 AT-SBx81GP24 Online

4 AT-SBx81XS6 Online

5 AT-SBx81CFC400 Online (Active)

6 - -

7 - -

8 - -

9 - -

10 - -

11 - -

12 - -

---------------------------------------------------------------------

===============================

x510_1, x908_VCS_1, x908_VCS_2:

===============================

% Invalid input detected at '^' marker.

atmf1[4]#

conf t

atmf1[4](config)#

int port2.1.1

% Can't find interface port2.1.1

atmf1[4:2](config-if)#

conf t