Ping – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 656
IP Addressing and Protocol Commands
Software Reference for x310 Series Switches
25.22
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
ping
This command sends a query to another IPv4 host (send Echo Request messages).
Syntax
ping [ip] <host> [broadcast] [df-bit {yes|no}] [interval <0-128>]
[pattern
[size <36-18024>] [source
255>]
Mode
User Exec and Privileged Exec
Example
To ping the IP address 10.10.0.5 use the following command:
Parameter
Description
<host>
The destination IP address or hostname.
broadcast
Allow pinging of a broadcast address.
df-bit
Enable or disable the do-not-fragment bit in the IP header.
interval <0-128>
Specify the time interval in seconds between sending ping
packets. The default is 1.
pattern
Specify the hex data pattern.
repeat
Specify the number of ping packets to send.
<1-2147483647>
Specify repeat count. The default is 5.
continuous
Continuous ping
size <36-18024>
The number of data bytes to send, excluding the 8 byte ICMP
header. The default is 56 (64 ICMP data bytes).
source
The IP address of a configured IP interface to use as the
source in the IP header of the ping packet.
timeout
<1-65535>
The time in seconds to wait for echo replies if the ARP entry is
present, before reporting that no reply was received. If no
ARP entry is present, it does not wait.
tos <0-255>
The value of the type of service in the IP header.
awplus#
ping 10.10.0.5