Ecofriendly led – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 213

System Configuration and Monitoring Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

Operating System - Version 5.4.4C

8.13

ecofriendly led

Use this command to enable the eco-friendly LED (Light Emitting Diode) feature, which
turns off power to the port LEDs, including the stack port status LEDs. Power to the system
status, SD and stack management LEDs is not disabled.

Use the no variant of this command to disable the eco-friendly LED feature.

Syntax

ecofriendly led

no ecofriendly led

Default

The eco-friendly LED feature is disabled by default.

Mode

Global Configuration

Usage

When the eco-friendly LED feature is enabled, a change in port status will not affect the
display of the associated LED. When the eco-friendly LED feature is disabled and power is
returned to port LEDs, the LEDs will correctly show the current state of the ports.

In a stack environment, enabling the eco-friendly LED feature on the stack master will
apply the feature to every member of the stack.

For an example of how to configure a trigger to enable the eco-friendly LED feature, see

“Turn Off Power to Port LEDs” on page 76.7

. See also the section

“Save Power With the

Eco-Friendly Feature” on page 1.32

Examples

To enable the eco-friendly LED feature which turns off power to all port LEDs, use the
following commands:

To disable the eco-friendly LED feature, use the following command:

Related Commands

ecofriendly lpi
show ecofriendly

awplus#