Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 396)

Switching Commands
Software Reference for x310 Series Switches
15.34 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show mirror interface
Use this command to display port mirroring configuration for a mirrored (monitored)
switch port.
Syntax show mirror interface <port>
Mode User Exec, Privileged Exec and Interface Configuration
Example To display port mirroring configuration for the port1.0.4, use the following commands:
Output Figure 15-7: Example output from the show mirror interface command
show platform
This command displays the settings configured by using the platform commands.
Syntax show platform
Mode Privileged Exec
Usage This command displays the settings in the running config. For changes in some of these
settings to take effect, the switch must be rebooted with the new settings in the startup
config.
Example To check the settings configured with platform commands on the switch, use the
following command:
Related Commands platform load-balancing
Parameter Description
<port> The monitored switch port to display information about.
awplus# configure terminal
awplus(config)# interface port1.0.4
awplus(config-if)# show mirror interface port1.0.4
Mirror Test Port Name: port1.0.3
Mirror option: Enabled
Mirror direction: both
Monitored Port Name: port1.0.4
awplus# show platform