Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1224)

AAA Commands
Software Reference for x310 Series Switches
45.2 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Command List
This chapter provides an alphabetical reference for AAA commands for Authentication,
Authorization and Accounting. For more information, see
Chapter 44, AAA Introduction
and Configuration .
aaa accounting auth-mac default
This command configures a default accounting method list for MAC-based
Authentication. The default accounting method list specifies what type of accounting
messages are sent and specifies which RADIUS Servers the accounting messages are sent
to. The default accounting method list is automatically applied to interfaces with MAC-
based Authentication enabled.
Use the no variant of this command to disable AAA accounting for MAC-based
Authentication globally.
Syntax aaa accounting auth-mac default {start-stop|stop-only|none}
group {<group-name>|radius}
no aaa accounting auth-mac default
Default RADIUS accounting for MAC-based Authentication is disabled by default
Mode Global Configuration
Usage There are two ways to define servers where RADIUS accounting messages are sent:
■ group radius : use all RADIUS servers configured by radius-server host command
■ group <group-name> : use the specified RADIUS server group configured with the
aaa group server command
The accounting event to send to the RADIUS server is configured with the following
options:
■ start-stop : sends a start accounting message at the beginning of a session and a
stop accounting message at the end of the session.
■ stop-only : sends a stop accounting message at the end of a session.
■ none : disables accounting.
Parameter Description
start-stop Start and stop records to be sent.
stop-only Stop records to be sent.
none No accounting record to be sent.
<group-name> Server group name.
radius Use all RADIUS servers