beautypg.com

Displaying provisioned configurations – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 2135

background image

VCStack Introduction

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

TM

Operating System - Version 5.4.4C

82.21

Switch ID 3 is then unprovisioned:

Run the show stack command to confirm that switch 3 has been unprovisioned.

Displaying Provisioned Configurations

In this respect the major difference associated with provisioning, is that interface
configurations will still exist in the config files and will appear in show commands, even
though a device itself may not be physically installed. This (provisioning) could result from
device capability that has been preconfigured for future installation, or could result from
the removal of an installed device.

The show running-config command includes switch commands for existing hardware,
plus all non-existent, but provisioned, hardware. The following example output of the
show running-config command illustrates how provisioned and existing hardware is
displayed.

awplus(config)#

no switch 3 provision

awplus#

show stack

Virtual Chassis Stacking summary information
ID Pending ID MAC address

Priority Status Role

1 -

0000.cd28.5377 128

Ready ActiveMaster

2 -

0000.cd29.95bf 128

Ready BackupMember

Note

Ensure that you save your running configuration to your startup configuration
after making any provisioning changes using copy running-config startup-
config

Figure 82-10: Sample display of existing and provisioned show output (

x310-26)

sh running-config
!
switch 1 provision

x310-26

!
interface port1.0.1-1.0.12
switchport
switchport mode access
!
.end