Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1091)

802.1X Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 41.25
show dot1x statistics interface
This command shows the authentication statistics for the specified interface, which may
be a static channel (or static aggregator) or a dynamic (or LACP) channel group or a switch
port.
For information on output options, see “Controlling “show” Command Output” on
page 1.37 .
Syntax show dot1x statistics interface <interface-list>
Mode Privileged Exec
Example See sample output below showing 802.1X authentication statistics for port1.0.6:
Parameter Description
The interfaces or ports to configure. An interface-list can be:
■
an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
■
a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen;
e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2, or
po1-2
■
a comma-separated list of the above;
e.g. port1.0.1,port1.0.4-1.0.6. Do not mix
interface types in a list
The specified interfaces must exist.
awplus# show dot1x statistics interface port1.0.6
802.1X statistics for interface
EAPOL Frames Rx: 5 - EAPOL Frames Tx: 16
EAPOL Start Frames Rx: 0 - EAPOL Logoff Frames Rx: 0
EAP Rsp/Id Frames Rx: 3 - EAP Response Frames Rx: 2
EAP Req/Id Frames Tx: 8 - EAP Request Frames Tx: 2
Invalid EAPOL Frames Rx: 0 - EAP Length Error Frames Rx: 0
EAPOL Last Frame Version Rx: 1 - EAPOL Last Frame
Src:00d0.59ab.7037