Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 406)

Switching Commands
Software Reference for x310 Series Switches
15.44 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show port-security intrusion
Shows the intrusion list. If the port is not specified, the entire intrusion table is shown.
Syntax show port-security intrusion [interface <port>]
Mode Privileged Exec
Example To see the intrusion list on port1.0.1, use the following command:
Output Figure 15-12: Example output from the show port-security intrusion command for
port 1.0.1
Parameter Description
interface Specify a port
<port> The port to display information about. The port may be a switch
port (e.g. port1.0.4), a static channel group (e.g. sa3), or a
dynamic (LACP) channel group (e.g. po4).
awplus# show port-security intrusion interface port1.0.1
Port Security Intrusion List
Interface: port1.0.1 -3 intrusion(s) detected
11-22-33-44-55-04 11-22-33-44-55-06 11-22-33-44-55-08