Lldp med-tlv-select, Lldp med-tlv-select all, No lldp med-tlv-select – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 1935: No lldp med-tlv-select all

LLDP Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

Operating System - Version 5.4.4C

71.9

lldp med-tlv-select

Use this command to enable LLDP-MED Organizationally Specific TLVs for transmission in
LLDP advertisements via the specified ports. The LLDP-MED Capabilities TLV must be
enabled before any of the other LLDP-MED Organizationally Specific TLVs are enabled.

Use the no variant of this command to disable the specified LLDP-MED Organizationally
Specific TLVs for transmission in LLDP advertisements via these ports. In order to disable
the LLDP-MED Capabilities TLV, you must also disable the rest of these TLVs. Disabling all
these TLVs disables LLDP-MED advertisements.

Syntax

lldp med-tlv-select {[capabilities] [network-policy] [location]

[power-management-ext] [inventory-management]}

lldp med-tlv-select all

no lldp med-tlv-select {[capabilities] [network-policy] [location]

[power-management-ext] [inventory-management]}

no lldp med-tlv-select all

Parameter

Description

capabilities

LLDP-MED Capabilities TLV. When this is enabled, the
MAC/PHY Configuration/Status TLV from IEEE 802.3
Organizationally Specific TLVs is also automatically
included in LLDP-MED advertisements, whether or not it
has been explicitly enabled by the

lldp tlv-select

command.

network-policy

Network Policy TLV. This TLV is transmitted if Voice VLAN
parameters have been configured using the commands:

■

switchport voice dscp

■

switchport voice vlan

■

switchport voice vlan priority

location

Location Identification TLV. This TLV is transmitted if
location information has been configured using the
commands: