Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 936)

IPv6 Hardware Access Control List (ACL) Commands
Software Reference for x310 Series Switches
36.4 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Command List
commit (IPv6)
Use this command to commit the IPv6 ACL filter configuration entered at the console to
the hardware immediately without exiting the IPv6 Hardware ACL Configuration mode.
This command forces the associated hardware and software IPv6 ACLs to synchronize.
Syntax commit
Mode IPv6 Hardware ACL Configuration
Usage Normally, when an IPv6 hardware ACL is edited, the new configuration state of the IPv6
ACL is not written to hardware until you exit IPv6 Hardware ACL Configuration mode. By
entering this command you can ensure that the current state of a hardware access-list that
is being edited is written to hardware immediately.
Scripts typically do not include the exit command to exit configuration modes, potentially
leading to IPv6 ACL filters in hardware not being correctly updated. Using this commit
command in a configuration script after specifying an IPv6 hardware ACL filter ensures
that it is updated in the hardware.
Example To update the hardware with the IPv6 ACL filter configuration, use the command:
Related Commands ipv6 access-list (named)
awplus# configure terminal
awplus(config)# ipv6 access-list my-ipv6-acl
awplus(config-ipv6-hw-acl)# commit