Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1287)

RADIUS Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 47.19
show radius statistics
This command shows the RADIUS client statistics for the switch.
Syntax show radius statistics
Mode User Exec and Privileged Exec
Example See the sample output below showing RADIUS client statistics and RADIUS configuration:
Output Figure 47-4: Example output from the show radius statistics command:
undebug radius
This command applies the functionality of the no debug radius command on page 47.3 .
awplus# show radius statistics
RADIUS statistics for Server: 150.87.18.89
Access-Request Tx : 5 - Retransmit : 0
Access-Accept Rx : 1 - Access-Reject Rx : 2
Access-Challenge Rx : 2
Unknown Type : 0 - Bad Authenticator: 0
Malformed Access-Resp: 0 - Wrong Identifier: 0
Bad Attribute : 0 - Packet Dropped : 0
TimeOut : 0 - Dead count : 0
Pending Request: 0