Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2152)

Stacking Commands
Software Reference for x310 Series Switches
83.12 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Example To display the detailed stacking information about the stack’s overall status:
Table 83-3: Parameters in the output from the show stack command
Parameter Description
ID Stack-ID and line card or control card slot.
MAC address Stack member MAC address.
Priority Stack member master election priority (between 0 and 255) Note that
the lowest number has the highest priority.
Role Stack member’s role in the stack, this can be one of:
■
Active Master.
■
Disabled Master (The temporary master when there is a
communication break within the stack, but communication still
exists across the resiliency link. In this state all switch ports within
the stack are disabled by default, but a different configuration can
be run by a “type stack disabled-master” trigger).
■
Backup Member (A device other than the stack master).
■
Provisioned - Indicates that the stack position is provisionally
configured, i.e. ready to accept a particular switch type into the
stack.
awplus# show stack detail