Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2108)

sFlow Commands
Software Reference for x310 Series Switches
81.14 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show debugging sflow
This command displays sFlow® debug settings for agent operation, and for sampling and
polling on specific interface ports. If no interface ports are specified, sampling and polling
will be applied to all ports.
Syntax show debugging sflow [interface <port-list>]
]
Mode User Exec and Privileged Exec
Example To display sFlow debug settings on the agent, and for sampling and polling on ports 1.0.1
to 1.0.9, use the command:
Output Figure 81-1: Sample obtained for an sFlow agent
To display sFlow debug settings for all ports, use the command:
Related Commands show running-config sflow
show sflow interface
Parameter Description
interface The interface information.
The ports for which the sFlow debug settings are to be shown.
The ports to display information about. The port list can be:
■
a switch port (e.g. port1.1.12)
■
a continuous range of ports separated by a hyphen,
e.g. port1.0.1-1.0.24
■
a comma-separated list of ports and port ranges,
e.g. port1.0.1,port1.1.1-1.2.24.
awplus# show debugging sflow interface port1.0.1-1.0.9
awplus# show debugging sflow interface port1.0.1-1.0.9
sFlow Agent Debug: Enabled
Sampling Polling
Port Debug Debug
-------------------------------
1.0.1 Enabled Enabled
1.0.2 Enabled -
1.0.3 - -
1.0.4 - -
1.0.5 - -
1.0.6 - Enabled
1.0.7 - -
1.0.8 - Enabled
1.0.9 - Enabled
awplus# show debugging sflow