Auth-web-server blocking-mode – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1164

Authentication Commands
Software Reference for x310 Series Switches
43.38
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
auth-web-server blocking-mode
Use this command to enable blocking mode for the web authentication server. The
blocking mode displays an authentication success or failure screen immediately from the
response result from a RADIUS server.
Use the no variant of this command to disable blocking mode for the web authentication
server.
Syntax
auth-web-server blocking-mode
no auth-web-server blocking-mode
Default
By default, blocking mode is disabled for the web authentication server.
Mode
Global Configuration
Example
To enable blocking mode for the web authentication server, use the following commands:
To disable blocking mode for the web authentication server, use the following commands:
Validation
Commands
Related Commands
show auth-web-server
auth-web-server mode
auth-web-server redirect-delay-time
Parameter
Description
blocking-mode
Use blocking authentication server process.
no
Disable blocking mode.
awplus#
configure terminal
awplus(config)#
auth-web-server blocking-mode
awplus#
configure terminal
awplus(config)#
no auth-web-server blocking-mode