Auth-web max-auth-fail – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 1162

Authentication Commands

Software Reference for x310 Series Switches

43.36

AlliedWare Plus

Operating System - Version 5.4.4C

C613-50046-01 REV A

auth-web max-auth-fail

This command sets the number of authentication failures allowed before rejecting further
authentication requests. When the supplicant (client device) fails more than has been set
to the maximum number of authentication failures then login requests are refused during
the quiet period.

The no variant of this command resets the maximum number of authentication failures to
the default (3 authentication failures).

Syntax

auth-web max-auth-fail <0-10>

no auth-web max-auth-fail

Default

The max-auth-fail lock counter is set to 3 authentication failures by default.

Mode

Interface Configuration for a static channel, a dynamic (LACP) channel group, or a switch
port.

Examples

To set the lock count to 5 on interface port1.0.2, use the following commands:

To set the lock count to the default on interface port1.0.2, use the following
commands:

Validation

Commands

show auth-web
show auth-web interface
show running-config

Related Commands

auth timeout quiet-period

Parameter

Description

<0-10>

Lock count specified.

awplus#

configure terminal

awplus(config)#

interface port1.0.2

awplus(config-if)#

auth-web max-auth-fail 5