Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 658)

IP Addressing and Protocol Commands
Software Reference for x310 Series Switches
25.24 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show debugging ip packet
Use this command to show the IP interface debugging status. IP interface debugging is set
using the debug ip packet interface command.
For information on output options, see “Controlling “show” Command Output” on
page 1.37 .
Syntax show debugging ip packet
Mode User Exec and Privileged Exec
Example To display the IP interface debugging status when the terminal monitor off, use the
command:
Output Figure 25-2: Example output from the show debugging ip packet command with
terminal monitor off
Example To display the IP interface debugging status when the terminal monitor is on, use the
command:
Output Figure 25-3: Example output from the show debugging ip packet command with
terminal monitor on
Related Commands debug ip packet interface
terminal monitor
awplus# terminal no monitor
awplus# show debug ip packet
awplus#terminal no monitor
awplus#show debug ip packet
IP debugging status:
interface all tcp (stopped)
interface vlan1 arp verbose (stopped)
awplus# terminal monitor
awplus# show debug ip packet
awplus#terminal monitor
awplus#show debug ip packet
IP debugging status:
interface all tcp (running)
interface vlan1 arp verbose (running)