Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1936)

LLDP Commands
Software Reference for x310 Series Switches
71.10 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Default By default LLDP-MED Capabilities, Network Policy, Location Identification and Extended
Power-via-MDI TLVs are enabled. Therefore, if LLDP is enabled using the
lldp run
command, by default LLDP-MED advertisements are transmitted on ports that detect
LLDP-MED neighbors connected to them.
Mode Interface Configuration
Usage LLDP-MED TLVs are only sent in advertisements via a port if there is an LLDP-MED-capable
device connected to it. To see whether there are LLDP-MED capable devices connected to
the ports, use the
show lldp neighbors command.
Examples To enable inclusion of the Inventory TLV Set in advertisements transmitted via ports 1.0.1
and 1.0.6, use the commands:
To exclude the Inventory TLV Set in advertisements transmitted via ports 1.0.1 and 1.0.6,
use the commands:
To disable LLDP-MED advertisements transmitted via ports 1.0.1 and 1.0.6, disable all
these TLVs using the commands:
Related Commands lldp tlv-select
location elin-location-id
location civic-location identifier
location civic-location configuration
location coord-location identifier
location coord-location configuration
location elin-location
show lldp interface
switchport voice dscp
switchport voice vlan
switchport voice vlan priority
all All LLDP-MED Organizationally Specific TLVs.
Parameter(cont.) Description(cont.)
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.6
awplus(config-if)# lldp med-tlv-select inventory-management
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.6
awplus(config-if)# no lldp med-tlv-select inventory-management
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.6
awplus(config-if)# no lldp med-tlv-select all