Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 380)

Switching Commands
Software Reference for x310 Series Switches
15.18 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
mac address-table static
Use this command to statically configure the MAC address-table to forward or discard
frames with a matching destination MAC address.
Syntax mac address-table static <mac-addr> {forward|discard} interface
<port> [vlan <vid>]
no mac address-table static <mac-addr> {forward|discard} interface
<port> [vlan <vid>]
Mode Global Configuration
Usage The mac address-table static command is only applicable to Layer 2 switched traffic
within a single VLAN. Do not apply the mac address-table static command to Layer 3
switched traffic passing from one VLAN to another VLAN. Frames will not be discarded
across VLANs because packets are routed across VLANs. This command only works on
Layer 2 traffic.
Example
Related Commands clear mac address-table static
show mac address-table
Parameter Description
The destination MAC address in HHHH.HHHH.HHHH format.
<port> The port to display information about. The port may be a switch port
(e.g. port1.0.4), a static channel group (e.g. sa2), or a dynamic
(LACP) channel group (e.g. po2).
The VLAN ID. If you do not specify a VLAN, its value defaults to vlan 1.
awplus# configure terminal
awplus(config)# mac address-table static 2222.2222.2222 forward
interface port1.0.4 vlan 3