Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1749)

DHCP for IPv6 (DHCPv6) Introduction and Configuration
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 65.13
Configure DHCPv6 Stateless Client
The Stateless Client can automatically learn about any gateway router(s) on the LAN via
router solicitation. It can then dynamically add associated default route(s) into its routing
table via the next-hop link-local address of the gateway router.
From RFC 4864, section 5.5.3: If the sum of the prefix length and interface identifier length
does not equal 128 bits, the Prefix Information option must be ignored.
The effect is that prefix information received in an RA will not be applied to form an IPv6
address via SLAAC if the prefix is greater or less than 64. Since EUI is 64 bits in length the
IPv6 Prefix of the advertising device must be 64 bits as well.
For command information, see the ipv6 address autoconfig command on the Stateless
Client.
Note bold configuration command entries show hostnames and interfaces.
Also note the default VLAN interface vlan1 is applied to all ports on a device.
Figure 65-5: DHCPv6 Stateless Client configuration topology:
Stateless_Client Configuration (SLAAC)
See the below configuration for a device with the hostname Stateless_Client:
hostname Stateless_Client
!
interface vlan1
ipv6 address autoconfig
dhcpv6_stateless_client1
Stateless_Client DHCPv6_Server
vlan1