Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1661)

AMF Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 60.73
switchport atmf-link
This command enables you to configure a port or aggregator to be an AMF uplink/
downlink. Running this command will automatically place the port or aggregator into
trunk mode.
The “no” variant of this command removes any AMF-link that may exist for the selected
port or aggregated link.
Syntax switchport atmf-link
no switchport atmf-link
Mode Interface Configuration
Example To make a switchport 1.0.1 an AMF crosslink, use the following commands
Parameter Description
switchport The Layer 2 Interface.
atmf-link Sets the switchport to be an AMF link.
Node_1# configure terminal
Node_1(config)# interface port1.0.1
Node_1(config-if)# switchport atmf-link