Show system pluggable detail – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 254
System Configuration and Monitoring Commands
Software Reference for x310 Series Switches
8.54
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
show system pluggable detail
This command displays detailed pluggable transceiver information showing the
pluggable type, the pluggable serial number, and the pluggable port on the switch.
Different types of pluggable transceivers are supported in different models of switch. See
your Allied Telesis dealer for more information about the models of pluggables that your
switch supports.
For information on output options, see
“Controlling “show” Command Output” on
Syntax
show system pluggable [<port-list>] detail
Mode
User Exec and Privileged Exec
Usage
For a stacked configuration, if this command is entered on the stack master, it will display
detailed information about the pluggable transceivers for all the stack members. A stack
member heading will be displayed to distinguish the different pluggable transceiver
information for every stack member.
In addition to the information about pluggable transceivers displayed using the
command (port, manufacturer, serial number, manufacturing
datecode, and type information), the show system pluggable detail command displays
the following information:
■
SFP Laser Wavelength: Specifies the laser wavelength of the installed pluggable
transceiver
■
Single mode Fiber: Specifies the link length supported by the pluggable transceiver
using single mode fiber
■
OM1 (62.5μm) Fiber: Specifies the link length (in μm - micron) supported by the
pluggable transceiver using 62.5 micron multi-mode fiber.
■
OM2 (50 μm) Fiber: Specifies the link length (in μm - micron) supported by the
pluggable transceiver using 50 micron multi-mode fiber.
■
Diagnostic Calibration: Specifies whether the pluggable transceiver supports DDM
or DOM Internal or External Calibration.
«
Internal is displayed if the pluggable transceiver supports DDM or DOM Internal
Calibration.
«
External is displayed if the pluggable transceiver supports DDM or DOM External
Calibration.
«
- is displayed if SFP or SFP+ DDM Internal Calibration or External Calibration is not
supported.
Parameter
Description
The ports to display information about. The port list can be:
■
a switch port (e.g. port1.0.12)
■
a continuous range of ports separated by a hyphen,
e.g. port1.0.1-1.0.24
■
a comma-separated list of ports and port ranges,
e.g. port1.0.1,port1.0.4-1.2.24.