Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1027)

QoS Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 39.21
mls qos map premark-dscp to
This command configures the premark-dscp map. It is used when traffic is classified by a
class-map that has
trust dscp configured. Based on a lookup DSCP, the map determines a
new DSCP, CoS, queue and band width class for the traffic.
The no variant of this command resets the premark-dscp map to its defaults. If no DSCP is
specified then all DSCP entries will be reset to their defaults.
Syntax mls qos map premark-dscp <0-63> to {[new-dscp <0-63>]
[new-cos <0-7>] [new-bandwidth-class {green|yellow|red}]}
no mls qos map premark-dscp [<0-63>]
Mode Global Configuration
Usage With the trust dscp command set, this command (mls qos map premark-dscp ) enables
you to make the following changes:
1. remap the DSCP (leaving the other settings unchanged)
2. remap any or all of CoS, output queue, or bandwidth class values (leaving the DSCP
unchanged)
Parameter Description
premark-dscp <0-63> The DSCP value on ingress.
new-dscp <0-63> The DSCP value that the packet will have on egress.
If unspecified, this value will remain the DSCP ingress
value.
new-cos <0-7> The CoS value that the packet will have on egress.
If unspecified, this value will retain its value on ingress.
new-bandwidth-class Modify Egress Bandwidth-class.
If unspecified, this value will be set to green.
green Egress Bandwidth-class green (marked down
Bandwidth-class).
yellow Egress Bandwidth-class yellow (marked down
Bandwidth-class).
red Egress Bandwidth-class red (marked down Bandwidth-
class).
Note If you attempt to remap both the DSCP and another setting, only the DSCP
remap will take effect.