Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 896
IPv4 Software Access Control List (ACL) Commands
Software Reference for x310 Series Switches
35.10
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
<destination>
The destination address of the packets. You can specify a single
host, a subnet, or all destinations. The following are the valid
formats for specifying the destination:
any
Matches any destination IP address.
host
Matches a single destination host with the
IP address given by
decimal notation.
<ip-addr>/
<prefix>
An IPv4 address, followed by a forward
slash, then the prefix length. This matches
any destination IP address within the
specified subnet.
<ip-addr>
<reverse-mask>
Alternatively, you can enter a reverse mask
in dotted decimal format. For example,
entering 192.168.1.1 0.0.0.255 is
the same as entering 192.168.1.1/24.
log
Logs the results.
The IP protocol number, as defined by IANA (Internet Assigned
Numbers Authorit
Protocol Number
Protocol Description [RFC Reference]
1
Internet Control Message [RFC792]
2
Internet Group Management [RFC1112]
3
Gateway-to-Gateway [RFC823]
4
IP in IP [RFC2003]
5
Stream [RFC1190] [RFC1819]
6
TCP (Transmission Control Protocol)
[RFC793]
8
EGP (Exterior Gateway Protocol) [RFC888]
9
IGP (Interior Gateway Protocol) [IANA]
11
Network Voice Protocol [RFC741]
17
UDP (User Datagram Protocol) [RFC768]
20
Host monitoring [RFC869]
27
RDP (Reliable Data Protocol) [RFC908]
28
IRTP (Internet Reliable Transaction Protocol)
[RFC938]
29
ISO-TP4 (ISO Transport Protocol Class 4)
[RFC905]
30
Bulk Data Transfer Protocol [RFC969]
Table 35-4: Parameters in the access-list extended (named) command - proto|ip|
Parameter(cont.
Description(cont.)