Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 582)

Link Aggregation Commands
Software Reference for x310 Series Switches
21.16 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show static-channel-group
Use this command to display all configured static channel groups and their corresponding
member ports. Note that a static channel group is the same as a static aggregator.
The command output also shows the thrash limiting status. If thrash limiting is detected
and the thrash limiting parameter of the
thrash-limiting command on page 15.49 is set
to vlan disable, the output will also show the VLANs on which thrashing is detected.
For information on output options, see “Controlling “show” Command Output” on
page 1.37 .
Syntax show static-channel-group
Mode User Exec and Privileged Exec
Example
Output Figure 21-10: Example output from the show static-channel-group command
Related Commands static-channel-group
awplus# show static-channel-group
% LAG Maximum : 128
% LAG Static Maximum: 96
% LAG Dynamic Maximum: 32
% LAG Static Count : 2
% LAG Dynamic Count : 2
% LAG Total Count : 4
% Static Aggregator: sa2
% Member:
port1.0.1
% Static Aggregator: sa3
% Member:
port1.0.2