Show system mac – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 249

System Configuration and Monitoring Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
8.49
show system mac
This command displays the physical MAC address available on a standalone switch, or a
stack. This command also shows the virtual MAC address for a for a stack if the stack virtual
MAC address feature is enabled with the
or the
command.
Syntax
show system mac
Mode
User Exec and Privileged Exec
Usage
This command also displays the virtual MAC address, if the VCStack Plus virtual MAC
address feature is enabled with the
command.
For information about this VCStack Plus feature, see the section
in the
chapter.
Example
To display the physical MAC address enter the following command:
Output
Figure 8-20: Example output from the
command
Output
Figure 8-21: Example output showing how to use the stack virtual-mac command
and the show system mac command:
Related Commands
awplus#
show system mac
awplus#show system mac
eccd.6d9d.4eed
awplus#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
awplus(config)#stack virtual-mac
% Please check that the new MAC 0000.cd37.0065 is unique within
the network.
% Save the config and restart the system for this change to take
effect.
Member1#copy run start
Building configuration...
[OK]
Member1#reload
reboot system? (y/n): y
... Rebooting at user request ...
Loading default configuration
....
awplus login: manager
Password:
awplus>show system mac
eccd.6d9d.4eed
Virtual MAC Address 0000.cd37.0065