Speed (asyn), Set the – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 264

System Configuration and Monitoring Commands
Software Reference for x310 Series Switches
8.64
AlliedWare Plus
TM
Operating System - Version 5.4.4C
C613-50046-01 REV A
speed (asyn)
This command changes the console speed from the switch. Note that a change in console
speed is applied for subsequent console sessions. Exit the current session to enable the
console speed change using the
clear line console
command.
Syntax
speed <console-speed-in-bps>
Default
The default console speed baud rate is 9600 bps.
Mode
Line Configuration
Usage
This command is used to change the console (asyn) port speed. Set the console speed to
match the transmission rate of the device connected to the console (asyn) port on your
switch.
Example
To set the terminal console (asyn0) port speed from the switch to 57600 bps, then exit the
session, and log in again to enable the change, use the commands:
Related Commands
line
clear line console
show running-config
show startup-config
speed
Parameter
Description
<console-speed-in-bps>
1200
2400
9600
19200
38400
57600
115200
Console speed Baud rate in bps (bits per second).
1200 Baud
2400 Baud
9600 Baud
19200 Baud
38400 Baud
57600 Baud
115200 Baud
awplus#
configure terminal
awplus(config)#
line console 0
awplus(config-line)#
speed 57600
awplus(config-line)#
exit
awplus(config)#
exit
awplus#
exit
The new console speed of 57600 bps is applied after exiting the session and before
login.
awplus login:
Password:
awplus>