Test – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 2035

Trigger Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

Operating System - Version 5.4.4C

77.15

test

This command puts the trigger into a diagnostic mode. In this mode the trigger may
activate but when it does it will not run any of the trigger’s scripts. A log message will be
generated to indicate when the trigger has been activated.

The no variant of this command takes the trigger out of diagnostic mode, restoring
normal operation. When the trigger activates the scripts associated with the trigger will be
run, as normal.

Syntax

test

no test

Mode

Trigger Configuration

Usage

Configure a trigger first before you use this command to diagnose it. See the

Configuring

a Trigger

section in

Chapter 75, Triggers Introduction

for trigger configuration steps.

Examples

To put trigger 5 into diagnostic mode, where no scripts will be run when the trigger
activates, use the commands:

To take trigger 205 out of diagnostic mode, restoring normal operation, use the
commands:

Related Commands

show trigger
trigger

awplus#

configure terminal

awplus(config)#

trigger 5

awplus(config-trigger)#