Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 942)

IPv6 Hardware Access Control List (ACL) Commands
Software Reference for x310 Series Switches
36.10 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
(ipv6 access-list named protocol filter)
Use this ACL filter to add a filter entry for an IPv6 source and destination address and
prefix, with an IP protocol type specified, to the current named IPv6 access-list. If a
sequence number is specified, the new entry is inserted at the specified location.
Otherwise, the new entry is added at the end of the access-list.
Note that specifying the send-to-cpu parameter could result in EPSR healthcheck
messages and other control packets being dropped.
The no variant of this command removes a filter entry for an IPv6 source and destination
address and prefix, with an IP protocol type specified, from the current named IPv6 access-
list. You can specify the filter entry for removal by entering either its sequence number, or
its filter entry profile.
Syntax [<sequence-number>
{deny|permit|send-to-cpu|send-to-mirror|copy-to-cpu|copy-to-
mirror}
{ipv6|proto <ip-protocol>}
{<ipv6-source-prefix/prefix-length>|<ipv6-source-address>
<ipv6-source-wildcard>|host <ipv6-source-host>|any}
{<ipv6-destination-prefix/prefix-length>|
<ipv6-destination-address> <ipv6-destination-wildcard>|
host <ipv6-destination-host>|any}
[<sequence-number>]
no {deny|permit|send-to-cpu|send-to-mirror|copy-to-cpu|copy-to-
mirror}
{ipv6|proto <ip-protocol>}
{<ipv6-source-prefix/prefix-length>|<ipv6-source-address>
<ipv6-source-wildcard>|host <ipv6-source-host>|any}
{<ipv6-destination-prefix/prefix-length>|
<ipv6-destination-address> <ipv6-destination-wildcard>|
host <ipv6-destination-host>|any}
no [<sequence-number>]
Parameter Description
<sequence-number> <1-65535>
The sequence number for the filter entry of the selected access control list.
deny Specifies packets to reject.
permit Specifies packets to permit.
send-to-cpu Specifies packets to send to the CPU. Specifying this parameter could
result in EPSR healthcheck messages and other control packets being
dropped.
send-to-mirror Specifies packets to send to mirror port.
copy-to-cpu Specifies packets to copy to the CPU.
copy-to-mirror Specifies packets to copy to the mirror port.
ipv6 Specifies IPv6 packet.
proto <ip-protocol> Specify IP protocol number <1-255>.