Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 1631
AMF Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
60.43
Related Commands
Current Action
The task that the AMF backup mechanism is currently performing. This will be a combination
of either (Idle, Starting, Doing, Stopping), or (manual, scheduled).
Started
The date and time that the currently executing task was initiated in the format DD MMM YYYY.
Current Node
The name of the node that is currently being backed up.
Node Name
The name of the node that is storing backup data - on its backup media.
Date
The data of the last backup in the format DD MMM YYYY.
Time
The time of the last backup in the format HH:MM:SS.
In ATMF
Whether the node shown is active in the AMF network, (Yes or No).
Status
The output can contain one of four values:
■
“-” meaning that the status file cannot be found or cannot be read.
■
“Errors” meaning that there are issues - note that the backup may still be deemed
successful depending on the errors.
■
“Stopped” meaning that the backup attempt was manually aborted;.
■
“Good” meaning that the backup was completed successfully.
Log File Location
All backup attempts will generate a result log file in the identified directory based on the node
name. In the above example this would be: card:/amf/office/logs/rsync_amf_testbox1.log.
Log Details
The contents of the backup log file.
Figure 60-6: Parameter definitions from the show atmf backup command(cont.)
Parameter
Definition
Note
You can manage your show output, or make it a more selective, by using a command
modifier. For information on using show-command modifiers, see:
.