Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 880)

IPv4 Hardware Access Control List (ACL) Commands
Software Reference for x310 Series Switches
34.34 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
The source address of the packets. You can specify a
single host, a subnet, or all sources. The following are
the valid formats for specifying the source:
any Matches any source IP address.
host Matches a single source host
with the IP address given by
in dotted decimal
notation.
<ip-addr>/
<prefix> An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any source
IP address within the specified
subnet.
<ip-addr>
<reverse-mask> Alternatively, you can enter a
reverse mask in dotted decimal
format. For example, entering
192.168.1.1 0.0.0.255
is the same as entering
192.168.1.1/24
.
<sourceport> The source TCP or UDP port number, specified as an
integer between 0 and 65535.
<destination> The destination address of the packets. You can specify
a single host, a subnet, or all destinations. The
following are the valid formats for specifying the
destination:
any Matches any destination IP
address.
host Matches a single destination
host with the IP address given
by in dotted
decimal notation.
<ip-addr>/
<prefix> An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any
destination IP address within
the specified subnet.
<ip-addr>
<reverse-mask> Alternatively, you can enter a
reverse mask in dotted decimal
format. For example, entering
192.168.1.1 0.0.0.255
is the same as entering
192.168.1.1/24
.
eq Equal to.
lt Less than.
gt Greater than.
Parameter(cont.) Description(cont.)