Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1581)

AMF Introduction and Configuration
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 59.37
Executing commands on working-sets
Once you have selected the desired working-set of nodes on which you wish to execute
commands, in general there is no difference to executing commands on a single
AlliedWare Plus device. When a command is executed that is valid for all nodes within the
working-set, the output is displayed for each of the nodes separately.
Here is an example output of the show arp command run from a working-set:
Some commands are invalid for nodes in a working-set
There will be some commands, however, which will only be valid to execute on some of
the nodes within the working-set. In this case the command will be executed on all nodes
within the working-set. However, for any node for which the command is not valid, the
command execution will fail and the output displayed will indicate the nodes on which
the command succeeded and nodes on which the command failed.
The following is example output of the show card command run from a working-set,
which is only a valid command for the SBx8100 series switches:
atmf1[4]#show arp
=======
Master:
=======
IP Address MAC Address Interface Port Type
172.31.0.1 eccd.6d7d.a542 ATMF sa1 dynamic
172.31.0.3 0000.cd2b.0329 ATMF sa1 dynamic
172.31.0.10 0000.cd37.0163 ATMF sa1 dynamic
=======
x510_1:
=======
IP Address MAC Address Interface Port Type
172.31.0.2 eccd.6d03.10f9 ATMF sa4 dynamic
===========
x908_VCS_1:
===========
IP Address MAC Address Interface Port Type
172.31.0.2 0000.cd37.1050 ATMF sa1 dynamic
===========
x908_VCS_2:
===========
IP Address MAC Address Interface Port Type
172.31.0.2 0000.cd37.1050 ATMF sa3 dynamic
atmf1[4]#