Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1754)

DHCP for IPv6 (DHCPv6) Commands
Software Reference for x310 Series Switches
66.2 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Command List
This chapter provides an alphabetical reference for commands used to configure DHCPv6.
For introductory information, see
Chapter 65, DHCP for IPv6 (DHCPv6) Introduction
and Configuration .
DHCPv6 is a network protocol used to configure IPv6 hosts with IPv6 addresses and IPv6
prefixes for an IPv6 network. DHCPv6 is used instead of SLAAC (Stateless Address
Autoconfiguration) at sites where centralized management of IPv6 hosts is needed. IPv6
routers require automatic configuration of IPv6 addresses and IPv6 prefixes.
For information about modifying or redirecting the output from show commands to a file,
see
“Controlling “show” Command Output” on page 1.37 .
clear counter ipv6 dhcp-client
Use this command in Privileged Exec mode to clear DHCPv6 client counters.
Syntax clear counter ipv6 dhcp-client
Mode Privileged Exec
Example To clear DHCPv6 client counters, use the following command:
Related Commands show counter ipv6 dhcp-client
clear ipv6 dhcp client
Use this command in Privileged Exec mode to restart a DHCPv6 client on an interface.
Syntax clear ipv6 dhcp client <interface>
Mode Privileged Exec
Example To restart a DHCPv6 client on interface vlan1, use the following command:
Note The IPv6 addresses shown use the address space 2001:0db8::/32, defined in RFC
3849 for documentation purposes. These addresses should not be used for
practical networks (other than for testing purposes) nor should they appear on
any public network.
awplus# clear counter ipv6 dhcp-client
Parameter Description
<interface> Specify the interface name to restart a DHCPv6 client on.
awplus# clear ipv6 dhcp client vlan1