Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1116)

Authentication Introduction and Configuration
Software Reference for x310 Series Switches
42.20 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Step 3: Enable 802.1X-authentication, Web-authentication, and MAC-
authentication:
Follow the instructions below to enable 802.1X-authentication, Web-
authentication, and MAC-authentication on switch ports to attach supplicant
devices. This authenticates the supplicant if any of the three methods that the
supplicant tries work, depending on the auth-fail VLAN settings. After enabling
the authentication, refer to earlier chapters to configure VLAN, IP address and
other authentication configurations for the authentication type you want.
awplus# configure terminal
awplus(config)# interface <interface-range>
awplus(config-if)# switchport mode access
awplus(config-if)# switchport access vlan 1
awplus(config-if)# auth-web enable
awplus(config-if)# auth-mac enable
awplus(config-if)# dot1x port-control auto
awplus(config-if)# auth dynamic-vlan-creation