Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 58)

Getting Started
Software Reference for x310 Series Switches
1.34 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Using the Find Me feature
The Find Me feature enables you to physically locate a specific device from a group of
similar devices.
Running the findme command on page 8.16 causes the device’s LEDs to alternately flash
green and amber at a rate of 1 Hz. If the switch has no amber LED, then the green LED will
flash on/off at a rate of 1 Hz.
An optional interface parameter specifies one or more interfaces to flash, while an
optional member parameter specifies a particular stack member. Both these parameters
are mutually exclusive. If no interface or member parameter is specified, then all ports on
the device or stack are flashed.
An optional timeout parameter specifies the flash behavior duration. The default time is
one minute (60 seconds). Normal LED behavior is restored automatically after either the
default time, or a specified time, has elapsed or a no findme command is used.