Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 2030)

Trigger Commands
Software Reference for x310 Series Switches
77.10 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
show trigger
This command displays configuration and diagnostic information about the triggers
configured on the device. Specify the show trigger command without any options to
display a summary of the configuration of all triggers.
Syntax show trigger [<1-250>|counter|full]
Mode Privileged Exec
Example To get summary information about all triggers, use the following command:
Parameter Description
<1-250> Displays detailed information about a specific trigger, identified by its
trigger ID.
counter Displays statistical information about all triggers.
full Displays detailed information about all triggers.
awplus# show trigger
Figure 77-3: Example output from the show trigger command
awplus#show trigger
TR# Type & Details Name Ac Te Tr Repeat #Scr Days/Date
---------------------------------------------------------------------------------
001 USB (in) Y N Y Continuous 0 smtwtfs
002 USB (out) Y N Y Continuous 0 smtwtfs
003 CPU (80% any) Busy CPU Y N Y 5 1 smtwtfs
005 Periodic (30 min) Regular status check Y N N Continuous 1 -mtwtf-
007 Memory (85% up) High mem usage Y N Y 8 1 smtwtfs
011 Time (00:01) Weekend access Y N Y Continuous 1 ------s
013 Reboot Y N Y Continuous 2 smtwtfs
017 Interface (vlan1 ... Change config for... Y N Y Once 1 2-apr-2008
019 Ping-poll (5 up) Connection to svr1 Y N Y Continuous 1 smtwtfs
---------------------------------------------------------------------------------
Table 77-1: Parameters in the output of the show trigger command
Parameter Description
TR#
Trigger identifier (ID).
Type &
Details
The trigger type, followed by the trigger details in brackets.
Name
Descriptive name of the trigger configured with the description
(trigger) command.
Ac
Whether the trigger is active (Y), or inactive (N).
Te
Whether the trigger is in test mode (Y) or not (N).
Tr
Whether or not the trigger is enabled to send SNMP traps. See the trap
command.
Repeat
Whether the trigger repeats continuously, and if not, the configured
repeat count for the trigger. To see the number of times a trigger has
activated, use the show trigger <1-250> command.