Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1789)

SNMP Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A AlliedWare Plus TM Operating System - Version 5.4.4C 68.7
show snmp-server
This command displays the status and current configuration of the SNMP server.
Syntax show snmp-server
Mode Privileged Exec
Example To display the status of the SNMP server, use the command:
Output Figure 68-4: Example output from the show snmp-server command
Related Commands debug snmp
show counter snmp-server
snmp-server
snmp-server engineID local
snmp-server engineID local reset
show snmp-server community
This command displays the SNMP server communities configured on the device. SNMP
communities are specific to v1 and v2c.
Syntax show snmp-server community
Mode Privileged Exec
Example To display the SNMP server communities, use the command:
Output Figure 68-5: Example output from the show snmp-server community command
Related Commands show snmp-server
snmp-server community
awplus# show snmp-server
SNMP Server .......................... Enabled
IP Protocol .......................... IPv4
SNMPv3 Engine ID (configured name) ... Not set
SNMPv3 Engine ID (actual) ............ 0x80001f888021338e4747b8e607
awplus# show snmp-server community
SNMP community information:
Community Name ........... public
Access ................. Read-only
View ................... none