beautypg.com

Stack disabled-master-monitoring – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 2157

background image

Stacking Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

TM

Operating System - Version 5.4.4C

83.17

stack disabled-master-monitoring

This command enables the Disabled Master Monitoring (DMM) feature. If a stack member
becomes a disabled master, the DMM feature will use the stack resiliency link to continue
monitoring the health of the separated stack master.

Use the no variant of this command to disable the DMM feature.

Syntax

stack disabled-master-monitoring

no stack disabled-master-monitoring

Default

By default, Disabled Master Monitoring is enabled. However, it only operates if there is a
resiliency link.

Mode

Global Configuration

Usage

This command enables additional stack resiliency link functionality, which is used if a stack
separation occurs. For DMM to operate, a resiliency link must also be configured (

stack

resiliencylink command on page 83.24

). A stack separation could result in a stack

member becoming a disabled master, which has the configuration as a normal stack
master except that all its switchports are shutdown.

For more information about the disabled master state, see

“Disabled Master” on

page 82.15

.

When the DMM feature is enabled, the disabled master will continue to monitor the
health of the original stack master over the stack resiliency link connection. If the original
stack master were to fail, when the DMM feature is enabled, then the disabled master will
detect this and will automatically re-enable its switchports. This ensures that the stack will
continue to pass network traffic, even if a catastrophic stack failure occurs.

For more information about the DMM feature when the stack member is a disabled
master, see

“Disabled Master Monitoring (DMM)” on page 82.16

.

Examples

To enable the DMM feature, use the following commands:

To disable the DMM feature, use the following commands:

Related Commands

show stack
stack resiliencylink
type stack disabled-master
type stack master-fail

awplus#

configure terminal

awplus(config)#

stack disabled-master-monitoring

awplus#

configure terminal

awplus(config)#

no stack disabled-master-monitoring