Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual
Page 721
Routing Commands
Software Reference for x310 Series Switches
C613-50046-01 REV A
AlliedWare Plus
TM
Operating System - Version 5.4.4C
29.7
Figure 29-1: Example output from the show ip route command
Connected Route
C 10.10.31.0/24 is directly connected, vlan2
This route entry denotes:
■
Route entries for network 10.10.31.0/24 are derived from the IP address of local
interface vlan2.
■
These routes are marked as Connected routes (C) and always preferred over routes
for the same network learned from other routing protocols.
Related Commands
Codes: C - connected, S - static, R - RIP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
* - candidate default
C 3.3.3.0/24 is directly connected, vlan1
C 10.10.31.0/24 is directly connected, vlan2
C 10.70.0.0/24 is directly connected, vlan4
C 33.33.33.33/32 is directly connected, lo