beautypg.com

Atmf backup enable, Command – Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) User Manual

Page 1593

background image

AMF Commands

Software Reference for x310 Series Switches

C613-50046-01 REV A

AlliedWare Plus

TM

Operating System - Version 5.4.4C

60.5

atmf backup enable

This command enables automatic AMF backups on the AMF master node. By default,
automatic backup starts at 3:00 AM. However, this schedule can be changed by the

atmf

backup command on page 60.3

. Note that backups are initiated and stored only on the

master nodes.

The ”no” variant of this command disables any AMF backups that have been scheduled
and previously enabled.

Syntax

atmf backup enable

no atmf backup enable

Default

Automatic AMF backup functionality is enabled on the AMF master when it is configured
and external media, i.e. an SD card or a USB storage device, is detected.

Mode

Global Configuration

Usage

A warning message will appear if you run the

atmf backup enable

command with either

insufficient or marginal memory availability on your external storage device.

You can use the command

“show atmf backup” on page 60.42

to check the amount of

space available on your external storage device.

Example

To turn on automatic AMF backup, use the following command:

Related Commands

show atmf
show atmf backup
atmf backup
atmf backup now
atmf enable

Parameter

Description

atmf

The Allied Telesis Management Framework (AMF)

backup

The AMF backup process.

enable

Enables AMF backup to external media.

VCF_1#

configure terminal

VCF_1(config)#

atmf backup enable