Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 1932)

LLDP Commands
Software Reference for x310 Series Switches
71.6 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
lldp holdtime-multiplier
This command sets the holdtime multiplier value. The transmit interval is multiplied by
the holdtime multiplier to give the Time To Live (TTL) value that is advertised to
neighbors.
The no variant of this command sets the multiplier back to its default.
Syntax lldp holdtime-multiplier <2-10>
no lldp holdtime-multiplier
Default The default holdtime multiplier value is 4.
Mode Global Configuration
Usage The Time-To-Live defines the period for which the information advertised to the neighbor
is valid. If the Time-To-Live expires before the neighbor receives another update of the
information, then the neighbor discards the information from its database.
Examples To set the holdtime multiplier to 2, use the commands:
To set the holdtime multiplier back to its default, use the commands:
Related Commands show lldp
Parameter Description
<2-10> The multiplier factor.
awplus# configure terminal
awplus(config)# lldp holdtime-multiplier 2
awplus# configure terminal
awplus(config)# no lldp holdtime-multiplier 2