Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 490)

Spanning Tree Introduction: STP, RSTP, and MSTP
Software Reference for x310 Series Switches
18.22 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
Advanced
configuration:
For most networks, the default settings of the following will be suitable. However, you can
also configure them.
■ path costs for ports in an MSTI ( spanning-tree mst instance path-cost ) or for the
CIST ( spanning-tree path-cost )
■ port priority for ports in an MSTI ( spanning-tree mst instance priority ) or for the
CIST ( spanning-tree priority (port priority) )
Check MSTP configuration
awplus(config)#
exit Return to Privileged Exec mode.
awplus#
show spanning-tree mst config Check that the digest is the same on this device as for all
other devices in the same region.
awplus#
show spanning-tree mst Check the MST to VLAN and port mapping.
awplus#
show spanning-tree mst instance Check the detailed information for a particular instance,
and all switch ports associated with that instance.
Specify the MST instance ID in the range 1 to 15.
awplus#
show spanning-tree mst interface Check general information about MSTP, and the CIST
settings.
Table 18-9: Configuration procedure for MSTP(cont.)