Allied Telesis AlliedWare Plus Operating System Version 5.4.4C (x310-26FT,x310-26FP,x310-50FT,x310-50FP) - Manual (Page 814)

MLD and MLD Snooping Introduction and Commands
Software Reference for x310 Series Switches
32.30 AlliedWare Plus TM Operating System - Version 5.4.4C C613-50046-01 REV A
ipv6 mld static-group
Use this command to statically configure IPv6 group membership entries on an interface.
To statically add only a group membership, do not specify any parameters.
Use the no variant of this command to delete static group membership entries.
Syntax ipv6 mld static-group
[source |ssm-map] [interface <port>]
no ipv6 mld static-group
[source |ssm-map] [interface <port>]
Mode Interface Configuration for a VLAN interface.
Usage This command applies to MLD Snooping on a VLAN interface to statically add groups and/
or source records.
Examples The following examples show how to statically add group and/or source records for MLD:
Parameter Description
<ipv6-group-
address> Specify a standard IPv6 Multicast group address to be
configured as a static group member.
The IPv6 address uses the format X:X::X:X.
<ipv6-source-
address> Optional. Specify a standard IPv6 source address to be
configured as a static source from where multicast
packets originate.
The IPv6 address uses the format X:X::X:X.
ssm-map Mode of defining SSM mapping. SSM mapping statically
assigns sources to MLDv1 groups to translate these (*,G)
groups' memberships to (S,G) memberships for use with
PIM-SSM.
<port> Optional. Physical interface. This parameter specifies a
physical port. If this parameter is used, the static
configuration is applied to just to that physical interface.
If this parameter is not used, the static configuration is
applied on all ports in the VLAN.
awplus# configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 mld static-group ff1e::10
awplus # configure terminal
awplus(config)# interface vlan2
awplus(config-if)# ipv6 mld static-group ff1e::10 source
fe80::2fd:6cff:fe1c:b